What a Tongue & Groove Router Bit Set Does
A tongue and groove router bit set lets you cut matching profiles on the edges of two boards so they lock together with a clean, strong joint. This joinery is a classic choice for Mission or Shaker-style cabinet doors, flat panel frames, and any project where you want simple, understated elegance without visible fasteners.
The set includes two separate cutters: one cuts the groove (a channel along the edge), and the other cuts the tongue (a matching ridge). Because they are factory matched, the fit is precise straight from the package.
Setting Up for 3/4" Material
The Infinity Tools 1/2" Shank Tongue & Groove Router Bit Set includes a FREE Setup block for 3/4" material. This block takes the guesswork out of aligning the cutters. Simply use it to set the bit height and fence position before making your first cut. The result is a consistent tongue height and groove depth every time.
The set produces either a 5.5 mm or 5.9 mm tall tongue, depending on the variant you choose. Both work with standard 3/4" stock for cabinet door frames.
Step-By-Step: Cutting the Joint on a Router Table
1. Install the groove cutter in your router table. Set the fence so the cutter is slightly proud of the bit's bearing, then use the setup block to adjust the bit height to match your material thickness.
2. Run the edge of the board that will receive the groove across the cutter. Use a push block and maintain steady feed pressure for a clean cut.
3. Switch to the tongue cutter. Adjust the fence and bit height using the same setup block. The tongue should be centered on the board edge.
4. Cut the tongue on the mating board. Test the fit: the tongue should slide into the groove with light hand pressure. If it's too tight, adjust the fence slightly and recut a test piece.
5. Once the fit is correct, cut all your frame pieces. Assemble the joints with glue and clamp until dry.
Infinity Tools Tongue & Groove Router Bit Set at a Glance
- Infinity Tools 1/2" Shank Tongue & Groove Router Bit Sets: Two-piece factory matched set with separate groove and tongue cutters. Produces a 5.5 mm or 5.9 mm tall tongue. Includes FREE Setup block for 3/4" material. Features anti-kickback 3-wing design on slot cutters. The factory matching ensures a tight joint without shimming, and the setup block eliminates measurement errors. The anti-kickback design adds safety during routing.

Infinity Tools 1/2" Shank Tongue & Groove Router Bit Sets
Choosing Between Tongue Thickness Variants
The set is available with either a 1/4" tongue thickness or a 5.5 & 5.9 mm option. The 1/4" variant is a standard imperial size for many cabinet door designs. The metric variant gives you two tongue heights in one set, which is useful if you work with slightly different stock thicknesses or want a tighter fit for certain panel styles. Both work with the same setup block and produce the same 1/2" profile width.
Tips for Clean Results
Always cut a test joint in scrap wood before working on your project pieces. This confirms the setup and lets you adjust the fence or bit height if needed.
Use sharp bits and feed the wood at a steady, moderate speed. Pushing too fast can cause tear-out, especially on the groove side. A router table with a featherboard helps keep the board flat against the fence.
For cabinet doors, cut the groove on the stiles (vertical pieces) and the tongue on the rails (horizontal pieces). This hides the end grain and gives the door a clean look.

