Frese Infinity Tools con gambo da 1/2" per pannelli verticali rialzati

The cut quality on these bits is outstanding—I milled a full set of maple raised panels with zero tear-out. They did require a bit of extra effort to push through with my 2-1/4 HP router, but the clean finish was worth it. Exactly what I needed for kitchen cabinet doors.

Set it up against a straight fence at 90 degrees and this bit just eats through the oak, leaving a clean profile with no burning or tear-out even on the end grain. I ran a whole set of drawer fronts with my 3-HP router and it held its edge the entire afternoon.

The cuts come out glass-smooth with zero tear-out on the panel faces, and the bit holds its edge through a full set of oak doors. I paired it with a 2-1/2 HP router and a 90-degree fence, and it powered through every pass without bogging down.