Why a Setup Block Riser Matters for Coping Sleds
When you use a coping sled like the Infinity Tools COP-200 or COP-201, the sled's base plate adds height between your router bit and the setup block. Without accounting for that extra thickness, your bit height will be off and your cope cuts won't match the mating profile. A dedicated setup block riser solves this by lifting your standard setup block by the exact amount needed to compensate for the base plate.
Setup Block Riser Details
- Infinity Tools Setup Block For Infinity Tools Coping Sleds: Pre-Machined Router Bit Setup Block Riser - For use with Infinity Coping Sleds. Made from pre-cut high density plastic. This riser is purpose-built for Infinity Coping Sleds (COP-200 and COP-201), so you don't have to guess or stack shims.

Infinity Tools Setup Block For Infinity Tools Coping Sleds
How to Use the Setup Block Riser
The process is straightforward and requires no special tools. You simply place the riser under your existing setup block before adjusting the bit height.
- 1. Position the riser on the router table or plate: Set the Infinity Tools setup block riser directly on the router table surface or insert plate, in line with your router bit.
- 2. Place your setup block on top of the riser: Set your standard Infinity Tools setup block (or any compatible setup block) on the riser. The riser lifts the block by the same thickness as the coping sled base plate.
- 3. Raise the router bit until it touches the setup block: With the router off, raise the bit until it just contacts the setup block. This accounts for the sled's base plate height, so your cope cut will be accurate.
- 4. Lock the router height and remove the riser and block: Lock the router in position, then remove the setup block and riser. Your bit is now set for use with the coping sled.
Tips for Consistent Results
Always ensure the riser and setup block are clean and free of debris before use. The high-density plastic construction of the Infinity Tools riser resists wear and won't compress under normal use, so you can rely on the same height adjustment every time. If you switch between different coping sleds or router plates, check that the base plate thickness is the same as the riser height.

